Corsair CW-9060024-WW Hydro Series H80i V2 120 mm High Performance All-In-One Liquid CPU Cooler - Black

Product Information

https://www.corsair.com/us/en/Categories/Products/Liquid-Cooling/Single-Radiator-Liquid-Coolers/Hydro-Series™-H60-%282018%29-120mm-Liquid-CPU-Cooler/p/CW-9060036-WW Secondly I switched the pump speed from silent to extreme and that caused the liquid T under normal browsing to fall down about 6-7 degrees. Maybe my fans profile is so "silent" that even the pump speed matters (usually it should not, or let's say "not so much"). Please note: For iCUE 4 on macOS, currently only HID and audio products (listed below under HID gaming peripherals) are supported.

Made some tries… first of all I cleaned the filters of my case (I found something I can barely assimilate to wool rather than dust), and that made me gain some degrees. The Corsair H80i v2 driver runs on your operating system and enables it to communicate with the CPU cooler you use. If the driver hasn’t been properly installed on your computer, your Corsair cooler won’t fully function.

Corsair does not list a maximum safe temperature, but every brand I know of puts it somewhere between 50-65C liquid temperature. It really doesn't matter for the physical pieces. Sealants and adhesives might not fare as well for long term exposure to 65C coolant. However, something of a moot point since 50C coolant will put your CPU temps into the 90s and force you to take action or shutdown. The CPU will always hit its limit first. So i'm building a new Alder lake pc, and I happen to have an H80i v2 from my previous one. I was very happy with its performance and would love to use it in my new H210i, since I gather it would be about the only AIO I could fit on the rear exhaust that could handle my new i5-12600K (I wanna leave the front rad slot open for a GPU cooler).

K70 RGB, K70 RGB PRO, K70 Lux RGB, K70 RGB Rapidfire, K70 RGB SE Rapidfire, K70 Lux, K70 Rapidfire, K70 PRO MINI question: as I mentioned before, my motherboard is the old P8Z77-I Deluxe which provides only 1 CPU fan header and 1 Chassis fan header, so when I install the pump, by common sense I will connect the fan 4-pin cable to the CPU fan header. But I know there is a pump fan lead cable, to where I should hook it up??Personally, I think those are good gaming temperature for Summertime and a H80i that is likely rear mounted above the GPU. The problem most users run into in that configuration is warmer than expected CPU temps during gaming as the GPU waste heat raises the baseline H80i coolant temp, simply through proximity to the GPU. What you are seeing is your own worst case scenario and yet you still have a fair amount of head room. As for the CPU only stress benchmarks, it is a Haswell so your CPU will always be the limiting factor in your cooling attempts, not the heat dissipation of the cooler. Be careful using BF1 as a diagnostic tool. There are too many variables in that one to make it reliable and it is clearly a peaky type of load. From there, proceed with your typical Hydro Series cooler installation (don't forget to plug in your power and USB cables). That depends on several factors. The pump that moves the liquid in the cooler is typically silent or at least inconsequential compared to other PC noises. AIO models usually have fans, which will get noisy if they operate at high speed or are dirty. You can decrease fan noise by keeping them free of dust and monitoring their settings via the BIOS if possible. The good news is that, with liquid cooling, fans usually don't have to work as hard and are less likely to make lots of noise.